BLINK LITE SKATEBOARD GOT WET PROFESSIONAL

Remove the battery (if possible) Bury your wet phone in a container of rice and place it in the sunlight (may take a few days) If it still doesn't function properly, consult a professional for repairs. When yours finally kicks the bucket, all you need to do is purchase a new one and replace it. Try these 5 fixes: Turn your phone off, if it isn't already.

Faulty BatteryĮvery battery goes bad eventually, including the ones inside of a hoverboard. They come pre-assembled, making this an easy project. After cleaning the phone, battery, SIM card, and SD card with alcohol, put them in a sealed bag of uncooked rice to dry. Stop riding your hoverboard if you see either of these lights and charge it as you normally would. Clean out the phone with alcohol for about 5 minutes. If the red light is blinking, it means your battery life is critically low and it needs to be charged immediately. The red light will blink four times for the motherboard side, and five times for the battery side.įixing this problem requires buying a new motor for the bad wheel, then replacing it disconnecting the old motor and reattaching the new one. When your hoverboard’s battery drops below 20, the green light will start to blink. These are tiny little devices that wire from the motherboard feed into the wheels. If resetting the device does not solve the problem, then a replacement kit is the only solution. This will also cause the board’s balance sensors to stop working. There are, however, replacement kits you can purchase for your board instead of buying a new one. Unfortunately, there’s no quick fix for malfunctioning internal circuits.

Blink lite skateboard got wet